ProComfort Protection Club
Worry-free home comfort all year long. Join thousands of members who never stress about their HVAC system.
What You Get — Plan by Plan
Every plan includes $0 diagnostic fees and priority scheduling. Pick the level of coverage that fits your home.
- Includes 1 visit: AC tune-up (spring) or furnace tune-up (fall)
- $0 diagnostic fee when you experience a problem (saves $89/visit)
- 10% off all repair labor
- Fast Pass Service (priority scheduling)
- 1-year repair warranty
- Peace of mind system protection
- Includes 2 visits: spring AC tune-up + fall furnace tune-up
- $0 diagnostic fee when you experience a problem (saves $89/visit)
- 15% off all repair labor
- Fast Pass Service (priority scheduling)
- 1-year repair warranty
- Free filter replacement (1/year)
- 5% off new equipment
- Includes 2 visits per system: spring AC + fall furnace tune-up
- $0 diagnostic fee when you experience a problem (saves $89/visit)
- 20% off all repair labor
- Fast Pass Service — VIP, first in line
- 2-year repair warranty
- Free filter replacements (2/year)
- 5% off new equipment
Repair discounts apply to labor charges. Parts and refrigerant are billed separately — plan covers all labor including diagnosis and recharge labor. Cancel anytime with 30 days' written notice.
What Happens at Every Tune-Up
Every precision tune-up / clean & check follows a comprehensive checklist — not a quick visual glance. Here's exactly what our NATE-certified technicians do at each visit.
Why Two Visits a Year?
Each visit covers your complete system — both the outdoor unit (AC/heat pump condenser) and the indoor unit (furnace/air handler). The reason for two visits is timing: your spring visit tests the cooling system under warm conditions so we can run the AC, check refrigerant, and confirm everything is ready before summer. Your fall visit tests the heating system before the first cold night — firing up the furnace, inspecting the heat exchanger for cracks, and verifying all safety controls.
Note on refrigerant: If a refrigerant leak is found during your spring visit, the plan covers all labor to diagnose and perform the recharge. Refrigerant itself (R-410A, R-32, etc.) is billed at cost — typically $85–$125/lb installed. Catching a small leak early is far less expensive than a compressor failure caused by running low all season.
Spring Visit — AC / Heat Pump (Outdoor + Indoor Coil)
- Outdoor condenser coils
- Evaporator coils (if accessible)
- Condensate drain line
- Fan blades & cabinet
- Refrigerant levels & pressure
- Evaporator & condenser coils
- Capacitors & contactors
- Blower motor & fan blades
- Thermostat calibration
- Electrical connections & voltage
- Safety & high-pressure controls
- Cooling start cycle & shut-off
- Lubricate motor bearings
- Check / replace air filter
- Verify airflow & static pressure
- Document system condition
Fall Visit — Furnace / Air Handler (Heating System)
- Burners & combustion chamber
- Heat exchanger surfaces
- Blower wheel & compartment
- Condensate drain (if applicable)
- Heat exchanger for cracks (CO hazard)
- Gas pressure & connections
- Ignition system & flame sensor
- Flue pipe & venting
- Thermostat calibration
- Electrical connections & voltage
- Safety & limit switches
- Heating start cycle & shut-off
- Lubricate motor bearings
- Check / replace air filter
- Verify airflow & static pressure
- Document system condition
Air filter replacement may be an additional charge depending on filter type. Technician will advise on-site.
Common Questions
What Members Are Saying
"The membership pays for itself with just one tune-up. The 15% repair discount alone has saved us hundreds — and knowing we're first in line when something breaks is priceless."
Ready to Protect Your Home?
Join the ProComfort Protection Club today and never worry about your HVAC system again.
